RULE BOOK DISCLAIMER
The rules and/or regulations set forth herein are designed to
provide for the orderly conduct of racing events and to establish
minimum acceptable requirements for such events. These rules shall
govern the condition of all events, and by participating in these
events, all participants are deemed to have complied with these
rules. NO EXPRESSED OR IMPLIED WARRANTY OF SAFETY SHALL RESULT FROM
PUBLICATIONS OF OR COMPLIANCE WITH THESE RULES AND OR REGULATIONS.
They are intended as a guide for the conduct of the sport and are in
no way a guarantee against injury or death to a participant,
spectator, or official.
The race director shall be empowered to permit reasonable and
appropriate deviation from any of the specifications herein or
impose any further restrictions that in his/her opinions do not
alter the minimum acceptable requirements. NO EXPRESSED OR IMPLIED
WARRANTY OF SAFETY SHALL RESULT FROM SUCH ALTERATION OF
SPECIFICATIONS. Any interpretation or deviation of these rules is
left to the discretion of the officials. Their decision is final.
2018 Batesville Motor Speedway Front Wheel Drive
1. Any Front Wheel Drive passenger car foreign or domestic must be
completely stock as manufactured, engine, drive train, suspension
and fuel system,, except as noted below. NO turbos. NO rear or mid
2. All glass, mirrors, body molding and trim must be removed.
Interior must be removed, but the dash may remain and be modified
for roll cage clearance.
3. A box type (6) point roll cage of at least 1
½ inch x .095 wall steel tubing is
required, and should be attached to the floor with ¾ x 4x8 inch
plates. Heavy angle or square tubing may be used. No threaded pipe
or pluming joints may be used. Cage must meet tech approval. Must
have door bars on both sides. Driver side must have three (3) bars 1
½ x.095 tubing. Passenger side may be "X" but must have Three
(3) bars. The roll cage must be box over, behind and in front of the
driver. The hoop behind the driver must have a diagonal brace. Roof
hoop must have center bar. Extra cockpit bracing is allowed.
4. Door must be welded or chained shut.
Windshield must be replaced and three (3) ⅜ inch diameter bars must
be in front of the driver. High wire mesh should also be added.
5. Strut towers, hubs and wheel centers
may be reinforced. Larger wheel studs recommended.
6. Passenger car tires only, no low
profile tires. Minimum inflation for all tires shall be 30PSI at all
times. No grooving or siping tires.
7. Fuel cell in steel can may be used
in place of OEM fuel tank and must be mounted in the trunk. Must
have fire wall between the tank and driver.
8. Battery may be relocated. If in
driver compartment it must be completely enclosed.
9. Racing seat mandatory with 5 point
racing harness. Seat or seat belts must mount to frame or roll cage.
Window net is highly recommended. Drivers must ware approved driver
safety equipment equipment. Must have fire extinguisher.
10. Cars must have readable numbers.